High-density and wide-bandwidth optical interconnects with silicon optical interposers [Invited]

来源 :PhotonicsResearch | 被引量 : 0次 | 上传用户:Richard0936
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
One of the most serious challenges facing exponential performance growth in the information industry is the bandwidth bottleneck in interchip interconnects. We propose a photonics–electronics convergence system in response to this issue. To demonstrate the feasibility of the system, we fabricated a silicon optical interposer integrated with arrayed laser diodes, spot-size converters, optical splitters, optical modulators, photodetectors, and optical waveguides on a single silicon substrate. Using this system, 20 Gbps error-free data links and a 30 Tbps/cm2 bandwidth density were achieved. This bandwidth density is sufficient to meet the interchip interconnect requirements for the late 2010s.
其他文献
We report here a single-pass 1.56 μm fiber gas Raman laser in a deuterium-filled hollow-core fiber and a 2.86 μm cascade fiber gas Raman laser with methane in the second stage. The maximum output powers at 1.56 and 2.86 μm are 27 and 8.5 mW with Raman con
对通常的玻璃壳连续氩离子激光器采用维弧激励二步法,可以获得寿命长、效率高的脉冲氩离子激光。磁场是脉冲氩离子激光提高功率输出的重要条件。脉冲氩离子激光用于液面法声全息提高了动态声全息的成象质量。
期刊
期刊
根据CO2 激光束加热材料的实际情况,建立了连续激光辐照材料的数学模型,并进行实验验证。结合实际的边界条件,采用微积分的数学处理方法推导出切割深度与激光参数的解析表达式,讨论了激光参数等因素对切割深度的影响。并且设计实验以验证理论模型,用Matlab 软件绘制各参数的关系图。结果表明:材料的切割深度受激光两个参数影响最大,激光功率与激光束移动速度。理论分析和试验结果表明切割深度随着切割速度的减小而增加,随着激光功率的增加而增大,并根据实验数据小幅修改了理论模型,该模型可对激光切割包装材料时在参数选择方面做
期刊
Microwave absorption and dielectric spectral detection technology with high time resolution (1 ns) is used for contactless measurement of electron property in solid materials. In this paper, the free photoelectron time-resolved spectra of cubic AgCl emuls
The goal of this research was to study the relationship between the eating quality of cooked rice and near infrared spectra measured by a Fourier Transform near infrared (FT–NIR) Spectrometer. Samples of milled: parboiled rice, white rice, new Jasmine ric
Optical coherence tomography (OCT) suffers from random noises which degrade contrast of image, these noises can not effectively be wiped off by filtering technique. Characteristics of random noises were discussed and analyzed, noise influences were identi
检测具有特殊空间结构的IC板引脚焊点缺陷时,相机镜头相对于引脚平面会有一定的倾斜角度,在特定的范围内获取图像清晰,超过此范围图像出现离焦模糊。针对此问题进行了研究,建立了景深的数学模型,推导出合理拍摄角度的公式,并通过实验进行了分析和验证。
对于红外输出图像的非均匀性,通常可采用两点校正法和神经网络法进行改善。但两点校正法不能有效地克服环境温度漂移的影响;神经网络法收敛缓慢,使静止图像逐渐融入背景,导致运动目标出现伪像。提出一种多本底采样自适应非均匀校正算法,在不同的环境温度点采集多组高低温本底,根据最小二乘法拟合计算得到非均匀校正系数和环境温度的关系,根据环境温度的改变自适应完成非均匀校正。测试结果表明,该方法简单可行,能够较好地克