目前市场上销售的新大洲50摩托车,质量与做工总体上讲还是很好的,但不少车出现行驶中化油器供油不足现象。据了解,这是由于化油器的主量孔、怠速量孔、油针等关键零件加工精度不够所造成的。 现介绍一下本人对此问题的处理方法,供朋友参考。 1.将柱塞式节气门的油针由第三格提至第四格,从而使加速和行驶时有足够的油量供给发动机。 Currently on the market for the new continent 50 motorcycles, quality and workmanship is still very good on the whole, but many cars appeared in the car carburetor running short of oil. It is understood that this is due to the carburetor main hole, idle hole, needle and other key parts of the accuracy caused by insufficient precision. Now I will deal with this issue, for your reference. 1. Put the plunger of the plunger throttle from the third grid to the fourth grid, so that there is enough oil for acceleration and driving to supply the engine.