Influence of Carrier Gas on Analysis of MgO Powders by Laser Ablation Inductively Coupled Plasma Mas

来源 :材料科学技术学报(英文版) | 被引量 : 0次 | 上传用户:zhegeyonghukeyi
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) has been widely adopted for the direct multi-elemental analysis with high sensitivity.Especially analysis of fine ceramics by LA-ICP-MS without time-consuming sample decomposition process has been one of the most expecting application field.Small additive elements in MgO powders were analyzed by LA-ICP-MS.For precise and accurate analysis influence of carrier gas (Ar or He) was presented by the signal intensities of ICP-MS, relative standard deviation of signal intensities and ablated particle size distribution.Ablated particles were collected and analyzed by scanning electron microscopy (SEM) to investigate the particle size distribution, and the ablated sample surface was examined by camscope.In He gas atmosphere, the signal was more stable than in Ar gas atmosphere.The signal intensity was higher in Ar than in He.Examination of ablated particles and sample surface reveals that more particles were generated in Ar atmosphere and the distribution of particle size was larger.
其他文献
Epitaxial YBCO superconducting films were deposited on the single crystal LaAlO3. (001) substrate by metal organic deposition method. All YBCO films were fired
The phosphor BaB8O13:Eu3+ were synthesized by solid-state reaction, and their luminescent properties were studied under 254 and 147 nm excitation. The excitatio
The amenability of a refractory ore to the extraction of gold and silver by cyanide leaching was investigated. Diagnostic leaching tests were also performed to
The isothermal oxidation behavior of a Ti3Al-based alloy (Ti-24Al-14Nb-3V-0.5Mo-0.3Si, molar fraction, %) at 700- 1 000 ℃ in air was investigated. The oxidatio
The separation techniques of vanadium and molybdenum were summarized, and a new method of removal V(Ⅴ) from Mo(Ⅵ) by adsorption with chelate resin was present
Numerical control(NC) bending experiments with different process parameters were carried out for 5052O aluminum alloy tubes with outer diameter of 70 mm, wall t
Ceramic LaNiO3 samples were prepared by solid state reaction method at different sintering temperatures. It was found that the resultant was not ABO3 perovskite
In recent times, conventional materials are replaced by metal matrix composites (MMCs) due to their high specific strength and modulus.Strength reliability, one
The alloys were prepared in Mg-rich corner of Mg-Zn-Ce system. Partial phase equilibrium relationships of these alloys at 350 ℃ were identified by using scanni
The novel felt-metal supported PVA composite hydrophilic ultrafiltration membrane was used for the treatment of oil/water(O/W) emulsion. The effects of transmem