This paper is focused on developing suitable methodology for predicting creep characteristics(i.e., the minimum creep strain rate, stress rupture life and time to a specified creep strain) of typical Ni-based directionally solidified(DS) and single-crystal(SC) superalloys. A modern method with high accuracy on simulating wide ranging creep properties was fully validated by a sufficient amount of experimental data, which was then developed to model anisotropic creep characteristics by introducing a simple orientation factor defined by the ultimate tensile strength(UTS). Physical confidence on this methodology is provided by the well-predicted transitions of creep deformation mechanisms. Meanwhile, this method was further adopted to innovatively evaluate the creep properties of different materials from a relative perspective. This paper is focused on developing suitable methodology for predicting creep characteristics (ie, the minimum creep strain rate, stress rupture life and time to a specified creep strain) of typical Ni-based directionally solidified (DS) and single-crystal (SC) superalloys . A modern method with high accuracy on simulating wide ranging creep properties was fully validated by a sufficient amount of experimental data, which was developed to model anisotropic creep characteristics by introducing a simple orientation factor defined by the ultimate tensile strength (UTS). confidence on this methodology is provided by the well-predicted transitions of creep deformation mechanisms. Meanwhile, this method was further adopted to innovatively evaluate the creep properties of different materials from a relative perspective.