Improvement on Diamond Nucleation Treated by Pulsed Arc Discharge Plasma

来源 :等离子体科学和技术 | 被引量 : 0次 | 上传用户:mrcena
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
A technique of improvement on diamond nucleation based on pulsed arc discharge plasma at atmospheric pressure was developed. The pulsed arc discharge was induced respectively by nitrogen, argon and methanol gas. After the arc plasma pretreatment, a nucleation density higher than 1010 cm-2 may be obtained subsequently in chemical vapor deposition (CVD) on a mirror-polished silicon substrate without any other mechanical treatment. The effects of the arc discharge plasma on the diamond nucleation were investigated by scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS), infrared spectroscopy (IR) and Raman spectroscopy. The enhancement of nucleation is postulated to be a result of the formation of carbonlike phase materials or nitrogenation on the substrate surface without surface defect produced by arc discharge.
其他文献
为探究吕家坨井田地质构造格局,根据钻孔勘探资料,采用分形理论和趋势面分析方法,研究了井田7
Plasma boundary identification is a basic task for studies on equilibrium and confinement in a divertor tokamak. With the progress on the experiments after engi
The carbon solubility in Mn-Fe melts were measured at 1350℃,1375℃,1425℃and 1450 ℃,and accordingly the calculated equations were obtained.By thermodynamic de
This paper proposes a novel optimization method of transient stability emergency control based on a new concept of the so-called extended practical dynamic secu
BEPCⅡ500MHz超导腔是BEPCⅡ储存环的关键设备,腔中高次模的分布和阻抗将很大程度上直接影响束流的稳定. 因此,研究BEPCⅡ超导腔的高次模分布和高次模吸收器的吸收效果对实现
A new approach to find the global optimal solution of the special non-convex problems is proposed in this paper. The non-convex objective problem is first decom
In this paper, optical fiber chaotic secure communication is proposed by coupling chaotic laser synchronous system with optical fiber propagation channel.Feedba
MHD stability of the Large Helical Device (LHD) plasmas produced with intense neutral beam injection is experimentally studied. When the steep pressure gradient
Nonwovens are fiber materials which are based on nonwoven technologies. For the complexity and randomness of nonwovens morphologic structures, it is difficult t
Augmented UD identification (AUDI) technique is derived from the traditional recursive least-squares (RLS) algorithm and has been developed rapidly during the l