直到现在,在切齿刀具的标准规格中,都是采用 S的齿厚。而在制造齿轮时,一定要有必要的侧向间隙,即减少齿的厚度,使S。 被切削齿轮齿部的变瘦,是藉将刀具向齿轮中心移动而得到;所移动的大小。是根据齿轮公差而定。这样一来,齿高就要加大。这一方法,在制造没有带齿腹加工的齿轮, Until now, the tooth thickness of S has been adopted in the standard specifications of a cutter cutter. In the manufacture of gears, we must have the necessary lateral clearance, that is, to reduce the thickness of the tooth so that S. Being cut gear teeth thinning, is obtained by moving the tool to the center of the gear; the size of the move. It is based on gear tolerance. As a result, tooth height will increase. This method, in the manufacture of gear without belly processing,