【摘 要】
：
Triggered spark-gap switch is a popular discharge switch for pulse power systems. Previous studies have focused on planarizing this switch using thin film techn
【机 构】
：
School of Chemical Engineering, Nanjing University of Science and Technology, Nanjing, 210094, China
论文部分内容阅读
Triggered spark-gap switch is a popular discharge switch for pulse power systems. Previous studies have focused on planarizing this switch using thin film techniques in order to meet the requirements of compact size in the systems. Such switches are one-shot due to electrodes being too thin to sufficiently resist spark-erosion. Additionally, these switches did not employ any structures in securing internal gas composition, resulting in inconsistent performance under harsh atmospheres. In this work, a novel planar triggered spark-gap switch (PTS) with a hermetically sealed cavity was batched-prepared with printed circuit board (PCB) technology, to achieve reusability with low cost. The proposed PTS was inspected by micro-computed tomography to ensure PCB techniques meet the requirements of machining precision. The results from electrical experiments demonstrated that PCB PTS were consistent and reusable with lifespan over 20 times. The calculated switch voltage and circuit current were consistent with those derived from real-world measurements. Finally, PCB PTS was used to introduce hexanitrostilbene (HNS) pellets in a pulse power system to verify its performance.
其他文献
国家职业教育改革要求使用新型活页式、工作手册式教材并配套开发信息化资源。在教学工作中,新型活页式、工作手册式校企合作开发教材是职业院校课程与教学评价指标中重要的一项,是促进职业院校进行教学改革、提高教学质量的重要工具。本文基于《图像处理》课程,自编活页式教材,概括新型活页式教材的特点,分析新型活页式教材的开发要点,对推动教材改革、提高教学质量起到积极的作用。
This paper presents an actuator used for the trajectory correction fuze,which is subject to high impact loadings during launch.A simulation method is carried out to obtain the peak-peak stress value of each component,from which the ball bearings are possi
采用时域有限差分法分析、模拟和设计了2D-3D异质结结构中的定向耦合器,并且通过非平面和平面的优化设计实现了小于2a(a为晶格常数)的超短耦合长度。研究结果表明,当位于耦合区域的晶格常数由1.25a-1.25a-1.25a-1.25a变为1.5a-2.0a-1.5a时,获得的耦合长度小于3a;同时将位于输入波导和耦合波导之间介质柱的宽度减小到0.18a,可获得小于2a的超短耦合长度。该耦合长度对于实现密度集成电路的小型化非常重要。
后进生一直是中小学教育教学中的一个比较敏感的话题,后进生的形成的原因多种多样,不同的成因解决的方式也不一样,其中主要原因可分为学生个人行为习惯、家庭关系、学校教育
针对某型潮流能水轮机复合材料叶片,提出了一种损伤特性分析方法.基于Tsai-Hill失效准则建立复合材料叶片损伤模型.针对正常运行工况的复合材料叶片,提出了一种损伤特性分析
The response characteristics of the warhead under thermal stimuli conditions are important to the safety improvement.The goal of this study is to obtain data on the warhead in the fast cook-off process.In this paper,a numerical calculation method is propo
In this paper,based on a bidirectional parallel multi-branch feature pyramid network(BPMFPN),a novel one-stage object detector called BPMFPN Det is proposed for real-time detection of ground multi-scale targets by swarm unmanned aerial vehicles(UAVs).Firs
采用环氧树脂改性聚氨酯,合成了增强尼龙树脂复合材料用玻璃纤维成膜剂,讨论了环氧当量的选择及用量对成膜剂的影响,并对产品进行了表征.结果表明:得到的乳液质量稳定,满足玻
以纤维缠绕成型的各工序为重点,从人、机、料、法、环5个方面分析了玻璃纤维缠绕成型过程中毛羽产生的原因,选取3种不同的玻纤产品,针对环境温度对玻纤毛羽产生的影响做了进
概述了固体表面润湿性等理论基础,随后重点综述了浸润性表面液滴定向输运的研究进展。浸润性表面液滴定向输运的驱动力主要来源于仿生结构或外场作用。其中对于仿生结构自驱动研究,概括总结了以蜘蛛丝、猪笼草和松针等自然界生物为仿生对象,依靠拉普拉斯压力差或表面能梯度实现液滴定向输运的相关研究,随后分析了其输运原理和优缺点,总结了其驱动力来源与理论公式。对于外场作用,其刺激源主要包括磁场、光场、电场、温度场和表面振动等,其中磁场作用力可以来源于液滴内部、液滴表面或液滴外部,光场主要包括近红外光、紫外光和可见光,电场主要