【摘 要】
：
The powder mixture of Cu and graphite was mechanically alloyed (MA) in an oscillating type ball mill. The milling time was varied in order to investigate its in
【机 构】
：
Key Laboratory of Automobile Materials,Jilin University,Department of Materials Science and Engineer
论文部分内容阅读
The powder mixture of Cu and graphite was mechanically alloyed (MA) in an oscillating type ball mill. The milling time was varied in order to investigate its influence on the microstructural evolution of mechanically alloyed powders. The phase constituent, alloying characteristics, grain size and lattice distortion of these powders were determined by X-ray diffraction, X-ray photoelectron spectroscopy, scanning electron microscopy and transmission electron microscopy. The results show that the C is confirmed to dissolve in the Cu lattice, forming solid solution of carbon in copper the lattice parameter of copper increases with carbon concentration increasing, up to a saturation value of about 4%C(mass fraction). Higher ball-mill energy is beneficial for twins and nanograin formation.
其他文献
A kind of aluminum cooler was manufactured by means of vacuum brazing technique, and the cooler was examined by hydraulic pressure test. The result indicates th
The titanium dioxide sols were synthesized with tetrabutyl titanate as precursor,diethanolamine(DEA) as complexing agent ,polyethylene glycol (PEG) as organic t
Half-metallic Fe3O4 films prepared by DC magnetron reactive sputtering with a tantalum(Ta) buffer layer was investigated. Primary emphasis is placed on the stru
In this paper, the authors present the transmission line (TL) realization of one-dimensional subwavelength resonator formed by a pair of conventional right-hand
In situ A356/TiB2 composites were successfully fabricated via in-melt reaction among aluminium alloy, K2TiF6 and KBF4 compounds. The composite was examined by u
The high performance magnesium alloy was investigated by adding B2O3 in magnesium and magnesium alloys. Experiments include adding B2O3 in Mg, Mg-Al and Mg-RE a
A multi-component polymer-coated molybdenum powder was chosen for selective laser sintering(SLS). The powder was prepared by coating polymer on Mo particles and
The challenge to rapid manufacturing high performance metal components is how to consolidate the uncompressed powder preforms to full or near full density witho
Laser shock processing is a very new technique and an emerging modern process that generates compressive stresses much deeper into the surfaces of metals or all
Quasi one-dimensional zinc oxide nanomaterials were synthesized by thermal evaporation. The structure,morphologies and composition of ZnO nanomaterials prepared