我厂一台DK6725B型机床能够对带有斜度的型腔零件进行切割,加工冷冲模的凹模和凹凸模等零件尤为理想。其线架结构如图1所示。它是依靠线架的上臂作前后左右移动,来实现线架的倾斜。由于运动形式关系,在实现斜度切割中下丝架是不动的。一般加工时,将工件的刃口向下,放在上、下线架的中间即垫快的位置Z,这样如果钼丝已对好 I plant a DK6725B-type machine capable of cutting the cavity with a slope of the parts, die processing die and punch and die and other parts is particularly desirable. The frame structure shown in Figure 1. It is to rely on the upper arm of the bobbin to move around, to achieve the tilt frame. Due to the relationship between the form of movement, the lower wire rack is not fixed during the cutting process. General processing, the workpiece edge down, on the lower frame of the middle of the pad faster position Z, so that if the molybdenum wire has been good