论文部分内容阅读
金钼股份三十亩地选矿厂以选钼为主,铜、硫为辅,其一段磨矿共有4个系统,均采用MQG3.6×4型湿式格子型球磨机与FX710型旋流器闭路循环工艺,其中4台球磨机一直沿用传统滑动轴承的支承方式,该方式影响球磨机的使用。1滑动轴承简介MQG3.6×4型球磨机进料端局部结构如图1所示。支承球磨机筒体部进料端轴颈上的滑动轴承由轴承盖、轴承座及附于两者之上的上、下轴承合金半瓦组成。出料端滑动轴承呈对称分布。
Gold and molybdenum thirty acres of the beneficiation plant to select the main molybdenum, copper, sulfur, a section of grinding a total of four systems are used MQG3.6 × 4-type wet lattice ball mill and FX710 cyclone closed loop Process, of which 4 ball mill has been used in traditional bearing bearing support, which affect the use of ball mill. 1 Sliding Bearing Introduction MQG3.6 × 4 type ball mill feed end of the local structure shown in Figure 1. The journal bearing on the feed end of the barrel supporting the mill body consists of a bearing cap, a bearing seat, and upper and lower bearing alloy half-watts attached to both. The discharge end of the plain bearings were symmetrical distribution.