Improvement of Cracking-resistance and Flexural Behavior of Cement-based Materials by Addition of Ru

来源 :武汉理工大学学报(材料科学版)(英文版) | 被引量 : 0次 | 上传用户:zhongkelong
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
By ring test and bend test,the improvement of waste tire rubber particles on the crack-resistance and flexural behaviors of cement-based materials were investigated.Test results show that the cracking time of the ring specimens can be retarded by the incorporation of rubber particles in the cement paste and mortar.The improvement in the crack-resistance depended on the rubber fraction.When the rubber fraction was 20%in volume,the cracking time was retarded about 15 h for the paste and 24 d for the mortar respectively.Flexural properties were evaluated based on the bend test results for both mortar and concrete containing different amount of rubber particles.Test results show that rubberized mortar and concrete specimens exhibit ductile failure and significant deformation before fracture.The ultimate deformations of both mortar and concrete specimen increase more than 2-4 times than control specimens.
其他文献
Nanocrystalline Gd1.77 Yb0.2Er0.03O3 samples were prepared by combustion and precipitation methods.Structures and upconversion luminescence properties of sample
YbCl3-MCl (M = Na, K, Rb, Cs) systems were optimized and calculated using the CALPHAD (CALculation of PHAse Diagram) technique. The modified quasi-chemical mode
The preparation of Al(OH)3 by the ion exchange membrane electrolysis followed by the precipitation of sodium aluminate solution with seeds was made. During the
随着现代生态环境遭到严重破坏的现状,如何更好的对现有生态环境加以保护,如何降低因经济发展而对生态环境造成的损害,如何提高人为生态工程的发展等都已经成为全世界人们所关注
Accurate solid concentration measurement plays a keY role in the process industry.Measurements analvzed offline can be used to estimate process efficiencies,to
目的对按照《中国药典》2010年版方法标定的氢氧化钠滴定液浓度进行不确定度评定。方法通过不确定来源分析,建立滴定液不确定度的数学模型,对标定过程中各种影响因素进行分析
采用混凝沉淀工艺对城市二级出水回用于火电厂循环冷却水系统进行深度处理,仅对浊度和CODCr有较好的去除,但出水中有机物和氨氮仍未达到火电厂循环冷却水系统的要求.为此,考
The properties of the passivation film formed on 316L stainless steel were studied by Electrochemical Impedance Spectroscopy(EIS),Mott-Schottky and Voltammetry
Tensile tests of solid solution treated 7050 aluminum alloy were conducted to different strain degrees (0.1, 0.4, 0.6 and failure) at 460 ℃ with the strain rat
A novel heat substrate technique,high frequency inductive heat deposition(IHD),was introduced to coat porous carbon materials,C/C and carbon felt to improve the