Electrical Properties and Electroluminescence of 4H-SiC p-n Junction Diodes

来源 :稀土学报(英文版) | 被引量 : 0次 | 上传用户:buffon149
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Homoepitaxial growth of 4H-SiC on off-oriented Si-face(0001 ) substrates was performed by using the step-controlled epitaxy technique in a newly developed low-pressure hot-wall CVD (LP-HWCVD) system with a horizontal aircooled quartz tube at around 1500 ℃and 1.33 × 104 Pa by employing SiH4 + C2H4 + H2. In-situ doping during growth was carried out by adding NH3 gas into the precursor gases. It was shown that the maximum Hall mobility of the undoped 4H-SiC epilayers at room temperature is about 430 cm2 ·V -1 ·s -1 with a carrier concentration of ~ 1016 cm-3 and the highest carrier concentration of the N-doped 4H-SiC epilayer obtained at NH3 flow rate of 3 sccm is about 2.7 × 1021 cm-3 with a mobility of 0.75 cm2 ·V -1 ·S -1. SiC p-n junctions were obtained by epitaxially growing N-doped 4H-SiC epilayers on Aldoped 4H-SiC substrates. The C-V characteristics of the diodes were linear in the 1/C3-V coordinates indicating that the obtained p-n junctions were graded with a built-in voltage of 2.7 eV. The room temperature electroluminescence spectra of 4H-SiC p-n junctions are studied as a function of forward current. The D-A pair recombination due to nitrogen donors and the unintentional, deep boron center is dominant at low forward bias, while the D-A pair recombination due to nitrogen donors and aluminum acceptors are dominant at higher forward biases. The p-n junctions could operate at temperature of up to 400 ℃, which provides a potential for high-temperature applications.
其他文献
The flow maldistribution and the effect of different inlet configuration on the flow distribution in platefin heat exchangers were studied experimentally. It is
The improvement of machining behavior of prehardened-mould steel for plastic is realized by using computer-aided composition design in this work. The results sh
The kinetics of bulk polymerization of octamethylcyclotetrasiloxane under acid circumstance is studied.A kinetic model is put forward and kinetic parameters are
A new nanometer-scale ferrite thin film with excellent high-frequency characteristics has been developed by the spray-spin-heating-coating method. The effects o
The surface oxidation films on H13 steel samples, obtained by different oxidation processes were observed by optical microscope. It is shown that the oxidation
Zirconia-ceria mixed oxide powders were prepared by high temperature aging method.The effects of the temperature and the time of aging, cerium content and calci
The mirror-confinement-type electron cyclotron resonance(MCECR) plasma source has high plasma density and high electron temperature. It is quite useful in many
With the applications of Nd-Fe-B material extending in recent years, the materials of neodymium metal and other rare earth metal alloy confront the increased de
Single phases of LnAlO3:Eu3+(Ln=Gd,Y) were obtained by the process of evaporation of their nitric acid solution, and then pyrolysis of their nitrate salts. On m
A new model based on the theoretical work of Boudh-Hir and Mansoori was developed for prediction of surface tension of pure fluids. The new model has the advant