【摘 要】
:
Establishment of a highly efficient regeneration system for the mature embryo of wheat will provide a convenient tool for wheat tissue culture and transformatio
【机 构】
:
National Key Facility of Crop Gene Resources and Genetic Improvement/Key Laboratory of Crop Genetics
【基金项目】
:
国家自然科学基金;the National Transgenic Organism Research Program of China
论文部分内容阅读
Establishment of a highly efficient regeneration system for the mature embryo of wheat will provide a convenient tool for wheat tissue culture and transformation,thereby facilitating the transformation of foreign genes into wheat.By using the mature embryos derived from 20 different wheat lines including Shi 4185,Yumai 66,Lunxuan 987,CB037,Yangmai 6,Xinchun 9,Bobwhite,Han 6172,Zheng 9023,Jimai 20,Ningchun 4,and Jing 411,the effects of some factors including inoculation methods,initiating culture media,organic additives,antioxidants,and auxins on the regeneration from the explants were evaluated.The results indicated that the scraping embryo culture was better than the whole embryo culture,the Aa medium was better than the SD2 medium and dicamba was better than 2,4-D in increasing the regeneration frequency.An Adi medium was established in this study by adding silver nitrate,cysteine,ascorbic acid,dicamba,glutamine into the Aa medium at the concentration of 4,40,100,2,and 5 mg L-1,respectively.By using the Adi medium and the scraping technique,the regeneration frequencies of the mature embryos of CB037,Lunxuan 987,Han 6172,Yangmai 6,Bobwhite,Zheng 9023,Shi 4185,and Jimai 20 became 85.6,60.1,46.0,42.1,42.0,34.0,33.0,and 32.0%,respectively,which were about 5-8 times higher than that obtained from the conventional culture mediums and techniques.This novel regeneration system could be helpful in wheat transformation.
其他文献
This paper gives a short introduction to the typical process route and material properties of these steels in comparison to standard martensitic corrosion-resis
A reasonable pre-treatment and an ultrasonic pre-plating Cu film were applied for sintering NdFeB permanent magnet. The samples were then plated in neutral bath
Amorphous gels were processed with a varying Fe/Ba ratio of 11/5, 28/2, 10.5/1 in water and Solvent. Iron and barium nitrites with specific molar ratio was solv
The present work has investigated the effect of trace elements Cd and Sn on the microstructure and mechanical properties of Al-Si-Cu-Mg cast alloy. With the inc
In the present reserch, a model has been proposed for estimate fracture toughness of Nickel-phosphorus (EN) layers. For this purpose, high phosphorus (9%) EN co
Nowadays, in the auto industry, the need for improvement of fuel efficiency is getting increased more and more in terms of the global warming, as well as the ne
The influence of zirconium on the resistance to high temperature softening of 6082 Al-Mg-Si alloys has been researched. The softening process of 6082 alloys wit
基于二维带输运模型,研究了LiNbO3:Fe晶体中光束从自散焦向自聚焦动态转换过程.结果表明暗辐照在动态转换过程中起着非常重要的作用,当暗辐照较小时动态转换过程才发生.在暗
Thermodynamic prediction of the increment of the formation temperature of proeutectoid ferrite by appliedstress is nearly consistent with the wxperfimental data
柞蚕生产是我区一项新兴产业,它投入少、效益高、周期短、见效快、技术简单等特点,已被林区职工所接受。我区有33万公顷柞林,20%用于放蚕,可解决1.2万人就业。