一般工厂的铸工车间在浇铸小件时,都是采取间断出铁浇铸的办法。也就是用大吊包出一包铁水再倒入小抬包里去浇铸。等到大吊包的铁水用完再去出铁。这种办法出铁水的周期太长,不能配合冲天炉的熔化,结果必然造成熔化和浇铸上的混乱。为了解决这个问题,我们做了一个铁水包的座架,如附图。铁水包放在座架 Casting shop in the general factory in the casting of small pieces, are taken intermittent cast iron casting approach. That is, with a large bag out of a bag of molten iron and then poured into the small lift bag to cast. Wait until a large bag of hot metal runs out of iron again. This method out of the molten iron cycle is too long, not with the Cupola melting, the result will inevitably cause melting and casting confusion. In order to solve this problem, we made a ladle seat, as shown in the photo. Ladle on the seat