论文部分内容阅读
４典型设备配置４郾１RP的配置对于PIM－SM而言，最根本的就是进行RP的设置。由于组播协议统一采用PIM－SMV２，因此我们利用BSR方式来确定RP。Cisco路由器上的具体配置如下：＜config＞＃ipmulticast－routingdistributed／设置启用组播路由，使Cisco的IOS软件能够转发组播数
4 Typical Equipment Configuration 4 郾 1RP Configuration For PIM-SM, the most fundamental thing is to set the RP. Because multicast protocols use PIM-SMV2 uniformly, we use BSR to determine the RP. The specific configuration on the Cisco router is as follows: # ipmulticast-routingdistributed / Set Enable Multicast Routing so Cisco IOS Software can forward multicasts