论文部分内容阅读
In this study,the types ofmicropores in a reservoir are analyzed using casting thin section (CTS) observation and scanning electron microscopy (SEM) experiments.The high-pressure mercury injection (HPMI) and constant-rate mercury injection (CRMI) experiments are performed to study the micropore structure of the reservoir.Nuclear magnetic resonance (NMR),gas-water relative seepage,and gas-water two-phase displacement studies are performed to examine the seepage ability and parameters of the reservoir,and further analyses are done to confirm the controlling effects of reservoir micropore structures on seepage ability.The experimental results show that Benxi,Taiyuan,Shanxi,and Shihezi formations in the study area are typical ultra-low porosity and ultra-low permeability reservoirs.Owing to compaction and later diagenetic transformation,they contain few primary pores.Secondary pores are the main pore types of reservoirs in the study area.Six main types of secondary pores are:intergranular dissolved pores,intragranular dissolved pores,lithic dissolved pores,intercrystalline dissolved pores,micropores,and microfracture.The results show that reservoirs with small pore-throat radius,medium displacement pressure,and large differences in pore-throat structures are present in the study area.The four types of micropore structures observed are:lower displacement pressure and fine pores with medium-fine throats,low displacement pressure and fine micropores with e throats,medium displacement pressure and micropores with micro-fine throats,and high displacement pressure and micropores with micro throats.The micropore structure is complex,and the reservoir seepage ability is poor in the study areas.The movable fluid saturation,range of the gas-water two-phase seepage zone,and displacement types are the three parameters that well represent the reservoir seepage ability.According to the characteristic parameters of microscopic pore structure and seepage characteristics,the reservoirs in the study area are classified into four types (Ⅰ-Ⅳ),and types Ⅰ,Ⅱ,and Ⅲ are the main types observed.From type Ⅰ to type Ⅳ,the displacement pressure increases,and the movable fluid saturation and gas-water two-phase seepage zone decrease,and the displacement type changes from the reticulation-uniform displacement to dendritic and snake like.