论文部分内容阅读
回顾涂塑制牙的历史，提出对此法应肯定其省工、省料、并可减轻劳动强度的优点；同时积极克服原用自凝塑胶存在的三个缺点，并延长涂塑成形的允许操作时间，形成相应工艺，则可达到与常规加热聚合法所制义齿相当的质量水平，进而超过传统法的质量．作者针对上述目标，研制出了以ＢＡＣＯ引发促进体系配成的涂塑材料．配合材料研制和将来气压聚合法的推广应用，又研制了多气源简易压力聚合器．通过６年多的临床应用，证明效果很好，并总结形成了一套操作工艺．本部分先侧重介绍器材的性能．
Recalling the history of plastic tooth making, put forward this method should be affirmed its provincial labor, save material, and reduce labor intensity advantages; the same time actively overcome the original use of self-adhesive plastic three shortcomings, and to extend the allowable plastic forming Operating time, the formation of the corresponding process, you can reach the conventional heating polymerization denture quality standards, and then surpass the quality of the traditional method. In response to the above objectives, the author developed a coating material that is promoted by BACO to promote the system. With the development of materials and the future application of pressure polymerization method, but also developed a simple multi-gas pressure polymerization. Through more than 6 years of clinical application, the results proved to be very good, and concluded that a set of operation process was formed. This section first focuses on the performance of equipment.