如果铣床全被占用了,还需进行一些铣槽或其它少量的铣削加工的话,那么常可采用车床来替代。 将铣刀置于冷轧钢做成的心轴上或者置于钻杆上,然后将它装在主轴卡爪内,在横向滑板上安装一个虎钳作为定位夹具,再使用一个垫块以便于定中心。铣槽时,把被加工工件固定好,使铣刀的中心对准工件的中心(见图),以主轴为基准,通 If the milling machine is occupied, but also for some milling or milling a small amount of other words, then you can often use lathes instead. Place the cutter on a cold-rolled steel mandrel or on a drill pipe, install it in the spindle jaw, install a vise on the cross-slide as a fixture, and then use a pad to facilitate Center. Milling slot, the workpiece is fixed so that the center of the cutter at the center of the workpiece (see Figure), with the spindle as a reference, through