【摘 要】
：
Si3 N4/TiC nanocomposite ceramics have been fabricated by hot pressing technique with Al2O3 and Y2O3 as additives.The results showed that well dispersed composi
【机 构】
：
Zhijie L(U)(School of Mechanical and Electronic Engineering,School of Mechanical Engineering
论文部分内容阅读
Si3 N4/TiC nanocomposite ceramics have been fabricated by hot pressing technique with Al2O3 and Y2O3 as additives.The results showed that well dispersed composite powder was carried out by adding dispersant and adjusting pH values of suspensions. Remarkable increase in flexural strength at room temperatures was obtained by adding nanoparticles in Si3N4 matrix with 10% (wt pct) of nano-Si3N4 and 15% of nano-TiC. The flexural strength, fracture toughness and hardness were 1025 MPa,7.5 MPa·1/2 and 15.6 GPa,respectively.The microstructures of materials were analyzed by scanning electron microscopy (SEM) and transmission electron microscopy (TEM), which indicated that TiC nanoparticles distribute in the matrix and at the grain boundaries. According to the fracture form, low contents of nano particles could refine matrix grains and lead to the crack deflection as well as crack pinning. The multiplex microstructure was formed by mixing nano-Si3N4 particles. The crack trajectories exhibited crack deflection, rod-like grain bridging and pull-out.
其他文献
Absorption of gaseous species into stationary droplets is a fundamental interest of mass transfer between liquid droplets and ambient gas, which plays a key rol
Single-phase homogeneous Ce1- xZrxO2 solid solutions with various compositions were synthesized using the reversed microemulsion method. The structural properti
Various micro-mechanical and micro-structural influences on fatigue crack growth resistance of the material have been investigated over the years. It is widely
The reduction mechanism of stainless steelmaking dust and carbon pellets was investigated. The metal oxides present in the dust were reduced by carbon with a ne
SiCf/Ti-6Al-4V composites were fabricated by the powder-coated fiber method. The precursor fiber was prepared under the optimized parameter, and the composites
Mixture of green petroleum coke, B4C and SiC together with short carbon fiber were employed as starting materials, the mixture was press-formed without any bind
Sapphire crystals with different orientations may cone from implantation of Nb+ ions under different conditions and succedent annealing at reducing atmosphere.
Extraction of the Ligusticum Chuanxiong oil with supercritical CO2 (SC-CO2) was investigated at the temperatures ranging from 55℃ to 70℃ and pressure from 25
Network-induced delay and jitter are key factors causing performance degradation and instability of NCSs (networked control systems). The relationships between
The CCT curves of supercooled austenite were investigated by using THERMECMASTOR-Z simulation machine, test samples refined from 50 kg vacuum induction furnace