Crystal Growth and Characterization of Ca3NbGa3Si2O14 Single Crystal

来源 :稀土学报(英文版) | 被引量 : 0次 | 上传用户:jmxhyundai
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Single crystals of Ca3NbGa3Si2O14 (CNGS) with ordered Ca3Ga2Ge4O14 (CGG) structure were successfully grown from stoichiometric melts by conventional Czochralski technique along the a-axis and two large (001) facets and two small (100) facets appear in every crystal. An arrangement of parallel steps and a clear height change were observed in (001) facet by atomic force microscopy (AFM). High-resolution X-ray diffraction (HRXRD) results indicate that CNGS crystals have good quality and free low-angle boundaries. The crystals also exhibit good optical quality and high optical transmittance in c-direction.
其他文献
Current—voltage (I—V) and capacitance-voltage (C—V) characteristics of Au/p-CZT contacts with different surface treatments on cadmium zinc telluride (CZT) wa
Compositional graded BaxSr1-xTiO3 (x=0.6,0.7,0.8,0.9,1.0) (BST) thin films (less than 400 nm) were fabricated on Si and Pt/Ti/SiO2/Si substrates by sol-gel tech
Low temperature sintering NiCuZn ferrite was employed at most cases due to its co-firability with Ag (below 960 ℃). The NiCuZn ferrite sintered body with high-
The carbon nanotube (CNT) growth of iron oxide-deposited trench-patterns and the locally-ordered CNT arrays on silicon substrate were achieved by simple thermal
Electrochemical methods were applied to investigate the corrosion behaviour of LY12CZ under applied stress in 3% sodium chloride aqueous solution. The experimen
A new metastable beta titanium alloy of Ti-Al-Mo-V-Cr-Fe-Zr-Sn system was designed and named Ti-B20. In order to investigate the aging properties and microstruc
Mg-6Al-4RE-0.4Mn (mass fraction, %, RE=Ce rich mischmetal) alloy was prepared by steel mould casting technique. Solid solution and artificial aging (T6) were ca
Y-shaped structure was synthesized by ethanol catalytic combustion(ECC) technique on the copper plate substrate,without directly seeding catalyst into the flame
Mg-(5-22)(mass fraction, %)Li alloys with Zn addition were produced and studied. The density of studied alloys is 1.19- 1.62 g/cm3. It is found that the alloy h
InAs quantum dots (QDs) grown on InxGa1-xAs/InP matrix by low pressure metal organic vapor phase epitaxy (LP-MOVPE) in nitrogen ambient were studied. Formation