我厂从装甲兵技术学院买回一台刷镀电源,其电源接头形状见图1。该接头焊接在电缆上,插头直径仅有4毫米,中间还有一豁口。若不小心摔在地上,很容易折断。如果重新加工新的,还要将接头处化开,很费事。于是我们对接头做了如下改进。将接头做成两部分,一个焊在电缆上(见图2),另一部分以螺纹形式(见图3)与图2件相连接。这样即使将图3φ4处摔断了,也会很快再换上一个图3所示的备件,极为方便,在生产 I plant from the Armored Force Technology bought a brush plating power supply, the power connector shape shown in Figure 1. The connector is soldered to the cable with a plug diameter of only 4 mm and a notch in the middle. If you accidentally fell to the ground, it is easy to break. If the reprocessing of new, but also to open joints, it is cumbersome. So we made the following improvements to the connector. The connector is made in two parts, one on the cable (see Figure 2) and the other on the thread (see Figure 3) to the Figure 2 connector. So even if Figure 3 ø 4 broken, will soon be replaced by a spare part shown in Figure 3, extremely convenient, in the production