用计算法确定大拖板下导轨面镶板厚度的方法,我们已经过几年实践,是一项成功的经验。现分以下三个步骤介绍。一、待镶导轨面的准备在修复好并精刮过的床身导轨上配制大拖板,使大拖板与导轨之间在长度方向的接触要好,角度贴合密切,点子不要求多。为了使大拖板运功平稳,刮研时要使导轨两端接触重一点,中间虚一些。二、测量与计算大拖板刮研完毕后,即可进 It has been a successful experience that we have been practicing for several years with the method of calculating the method of determining the thickness of the panel under the rail with a large carriage. The following three steps are introduced. First, to be inlaid rail surface preparation Good repaired and refined over the bed rails on the preparation of a large carriage, so that the big carriage and rail in the length direction of the contact is better, the angle fit closely, ideas do not require more. In order to make the large carriage work smoothly, scraping the rail to make contact at both ends of a little heavier, the middle of some virtual. Second, measurement and calculation Scratch scraping research is completed, you can enter