Superplasticity and diffusion bonding of magnesium alloy ZK60

来源 :中国有色金属学会会刊(英文版) | 被引量 : 0次 | 上传用户:panyh921
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Superplasticity of as-rolled ZK60 magnesium alloy sheets, with the average grain size of 8.2μm, was investigated at a strain rate of 5.56×10-4-5.56×10-2 s-1 at 573-673K. The microstructure evolution during the superplastic deformation shows that the alloy deforms in a superplastic manner at the temperature from 573K to 673K. Diffusion bonding tests were carried out on the Gleeble-1500 testing machine and the specimens were successfully diffusion bonded at the superplastic temperature. The maximum specific strength is 0.82 at a bonding pressure of 10MPa for holding time 1h at 673K. The microstructures of the joints were observed through OM and SEM. There is no bond line visible in the original interfaces of sound joint with high specific strength.
其他文献
Sapphire crystals with different orientations may cone from implantation of Nb+ ions under different conditions and succedent annealing at reducing atmosphere.
Extraction of the Ligusticum Chuanxiong oil with supercritical CO2 (SC-CO2) was investigated at the temperatures ranging from 55℃ to 70℃ and pressure from 25
Network-induced delay and jitter are key factors causing performance degradation and instability of NCSs (networked control systems). The relationships between
The CCT curves of supercooled austenite were investigated by using THERMECMASTOR-Z simulation machine, test samples refined from 50 kg vacuum induction furnace
Si3 N4/TiC nanocomposite ceramics have been fabricated by hot pressing technique with Al2O3 and Y2O3 as additives.The results showed that well dispersed composi
The structure and disorder-order transformation of NdxFe60.5-xPt39.5(x = 0, 0.5, 1.0, 1.5) alloys were investigated in situ by high temperature X-ray diffractio
In order to improve the quality of the bio-active coating on medical grade CoNiCrMo substrate, hydroxyapatite(HA) coatings were produced via low-temperature dip
TiO2/SiO2 aerogels with different molar ratio of SiO2/TiO2 were prepared via non-supercritical method using tetrabutyl titanate and silica sols as raw materials
Mobile robot global path planning in a static environment is an important problem. The paper proposes a method of global path planning based on neural network a
After the investigation on partial remelting of thixotropic magnesium serial alloys (ZK60) by near non-equilibrium liquidus casting (NNLC), the primary solid gr